The key to sizing an elongated light fixture is proportion. We recommend selecting a light measuring no more than 2/3 the length of the table or island. Consider hanging a pair of linear fixtures to light extra long surfaces.

For spaces with lower ceilings or door thresholds in close proximity, we recommend choosing flush or semi-flush mounts that will leave a minimum of 213.5 cm from the bottom of the fixture to the floor. These low-profile fixtures will allow for more overhead space and draw the eye upward, making the ceiling appear taller.

As a rule of thumb, the width of the shade of your picture light should measure approximately 1/2 the width of the frame or artwork below. For best results, position the light at a 30-degree angle from the illuminated artwork.

When installing multiple wall sconces to accent a hallway, dining room or other living space, consider leaving a minimum of 2.45 – 3 m between each fixture for a balanced spread of light.

If your sconce has a switch, be sure to install it where it can be easily reached from a sitting position in the bed. For best results, leave approximately 140 – 152.5 cm of space from the floor to the top of the sconce.

To evenly illuminate a bathroom mirror from either side, we recommend mounting your sconce(s) just above eye level, or about 152.5 – 165 cm from the floor to the center height of the sconce backplate.

The ideal linear bath light will measure at least 3/4 the width of the mirror but not extend over its edges. For larger mirrors, consider mounting a pair of evenly-spaced linear sconces.